next up previous contents index
Next: 2.3.6.1 Installing Slackware with Up: 2.3 Installing the Linux Previous: 2.3.5 Creating the filesystems

2.3.6 Installing the software

 

Finally, you are ready to install the software on your system. Every distribution has a different mechanism for doing this. Many distributions have a self-contained program which will step you through the installation. On other distributions, you will have to mount your filesystems in a certain subdirectory (such as /mnt) and copy the software to them by hand. On CD-ROM distributions, you may be given the option to install a portion of the software on your hard drives, and leave most of the software on the CD-ROM.

Some distributions offer several different ways to install the software. For example, you may be able to install the software directly from an MS-DOS partition on your hard drive, instead of from floppies. Or, you may be able to install over a TCP/IP network via FTP or NFS. See your distribution's documentation for details.

For example, the Slackware distribution only requires you to create partitions with fdisk, optionally create swap space with mkswap and swapon (if you have 4 megs or less of RAM), and then run the setup program. setup leads you through a very self-explanatory menu system to install the software.

Use of setup is described in detail below.

The exact method used to install the Linux software differs greatly with each distribution. We're hoping that installing the Linux software should be self-explanatory, as it is with most distributions.





next up previous contents index
Next: 2.3.6.1 Installing Slackware with Up: 2.3 Installing the Linux Previous: 2.3.5 Creating the filesystems



Matt Welsh
mdw@sunsite.unc.edu